Kent’s tap water is hard, and in places very hard, and solar panel makers advise against cleaning with water that is high in minerals. That is why professional cleaners here use purified water. Tap water is not a disaster, but it is not the best tool either.
How hard is Kent’s water?
South East Water runs a postcode checker for the areas it supplies. In November 2026 it gave these figures, measured as milligrams of calcium carbonate per litre:
| Place (supply zone) | Hardness | Drinking Water Inspectorate band |
|---|---|---|
| Canterbury | 308 mg/l | Very hard |
| Whitstable | 293 mg/l | Hard |
| Faversham (North Downs zone) | 292 mg/l | Hard |
| Herne Bay (Herne zone) | 287 mg/l | Hard |
| Maidstone (Boxley zone) | 243 mg/l | Hard |
The bands are the Drinking Water Inspectorate’s: soft up to 100, slightly hard 100 to 150, moderately hard 150 to 200, hard 200 to 300, and very hard above 300.
Figures are for a supply zone, so yours may differ a little; put your own postcode into the checker. We could not get figures for Thanet, Ashford, Dover or Folkestone when we checked. Your own water company’s website will have them.
The reason is geology. South East Water explains: “Most of the water we supply in Southern England comes from underground chalk aquifers, so the water is hard.” It is perfectly good to drink. It is the same water that furs up your kettle.
What the panel makers say
Makers do not all say the same thing, so here is each one in its own words.
- REC is the strictest. Its installation manual says: “Use only deionized water free from grit and physical contaminants”, adding that rainwater or tap water “may also be used as a secondary solution”.
- LONGi says that “Municipal domestic water can be used”, but also that “It is not recommended to use water with high mineral content, because the minerals in the water will deposit on the glass surface after long-term use”. For other water sources it sets a hardness limit of 450 mg/l.
- Canadian Solar recommends “cleaning water with low mineral content and a pH value close to neutral”.
- JinkoSolar says water with a high mineral content “may leave deposits on the glass surface and is not recommended”.
Put together: no maker says a wash with tap water will wreck a panel, and Kent’s water is inside LONGi’s limit. But most of them steer you towards water with little in it, and the concern they share is deposits building up on the glass over repeated cleans.
What purified water is
Purified water is tap water with the dissolved minerals taken out, by reverse osmosis, by a deionising resin, or both. Cleaners check it with a meter that reads total dissolved solids, and aim for a reading at or near zero.
Because there is nothing dissolved in it, it dries without leaving spots. That also means no detergent is needed and nothing has to be wiped off afterwards, which is what lets a cleaner work from the ground with a brush on a long pole.
If you are cleaning your own panels
- Tap water is fine for loosening dirt. Use plenty, and a soft brush or sponge.
- Avoid letting hard water bake dry on the glass. Clean when the panels are cool. REC says cleaning “must always be carried out when the panels are cool, e.g., early morning”.
- A final rinse with deionised water helps. The kind sold for irons and car batteries will do for a small array.
- Never scrape at white spots. If old water marks won’t shift with water and a soft cloth, leave them and ask your installer.
The full method is in our guide to cleaning your own solar panels.
What we use
We filter Kent tap water until it is as close to pure as we can get it, and clean with that and a soft brush. Nothing else goes on the glass. You can see our prices or book online.